Description:

Zipwall SLP2 12' Spring Loaded Poles for Zip Wall Dust Barrier System 2 Pack

ZipWall^® 12 spring-loaded dust barrier poles are designed for the professional contractor. They are easy to use, easy to store, and a significant time saver! These poles are strong and lightweight, telescope up to 12 feet high and twist to lock. Each spring-loaded pole takes seconds to set up without a ladder. The innovative non-skid, non-marking head locks the barrier material, allowing it to be raised with the pole, and holds it securely in place without damaging the ceiling. A tight dust barrier can be set up in just a few minutes, one pole at a time, without ladders, tape, or damage.

The ZipWall^® 12 poles are the prime ZipWall^® poles. Anodised aluminium construction makes them sturdier than stainless steel, smoother to raise and to lock, and the best foundation for ZipWall^® accessories like FoamRail™ tape less seals. These poles are built for heavy use and their size is perfect for both residential and commercial jobs.

The 2-Pack is ideal for adding to your ZipWall^® Dust Barrier System. Two poles can also be used to close off a hallway or small room less than 10 feet wide.

Key Features:

• Spring-loaded design for quick, easy, and safe setup
• Strong and lightweight anodised aluminium construction
• Telescope up to 12′ (from 4′ 7″)
• Innovative non-skid, non-marking head and plate
• Each pole weighs just 2 lb
• GripDisks™ prevent sliding on smooth floors
• Work with positive and negative air
• Help comply with the EPA RRP rule

Contents:

Two 12′ anodised aluminium spring-loaded poles with parts (heads, plates, and GripDisk™ non-slip pads). Plastic sheeting is not included.

Tips for setting up a dust barrier:

• When using plastic, cut it to size ahead of time.
• Set up the barrier one pole at a time starting at the wall. Leave the plastic loose at the bottom and make sure the spring at the top of the pole is not compressed all the way.

Once ALL poles are in place, do the following:

• Tuck the plastic under each pole.
• Place a GRIP DISK on the floor under the pole.
• Compress the spring at the top of each pole all the way up.